Chapter 7 Specifications - Hitachi SH1 Series Basic Manual

Chapter 7

Chapter 7 Specifications

7.1 400V class specifications
Model name(format)
00041 00054 00083 00126 00175 00250 00310 00400 00470 00620 00770 00930 01160 01470 01760 02130 02520 03160
SH1-*****-H
ND standard capacity
007
SH1-***H
VLD
Applicable motor 1.5
capacity (4 LD
1.5
poles)(kW)
ND
0.75
VLD 4.1
Rated
output LD 3.1
current(A)
ND 2.5
VLD
Overload
current LD
rating
ND
Rated output
voltage
VLD 2.8
400V LD
2.1
Rated
capac ND 1.7
ity
VLD 3.6
(kVA)
460V LD 2.7
ND 2.2
VLD 4.9
Rated input
current(A) LD 3.7
*1)
ND 3.0
Rated input AC
voltage *2)
Power
VLD 3.7
supply
LD 2.8
capacity
ND 2.3
(kVA) *3)
VLD
Carrier
frequency
LD
variation *4)
ND
Starting torque *5)
Regenerative
Minimum
100
resistance value(Ω)
H(height)(mm)
255
W(width)(mm)
150
D(Depth)(mm)
140
Protective structure
Aprox. weight (kg)
4
*1) The rated input current is the value when the drive is operated in the
rated output current. The value of the impedance at the supply side
changes due to the wiring, breaker, input reactor, etc.
*2) Make sure the following for Low Voltage Directive (LVD) compliant.
- Pollution degree 2
- Overvoltage category 3 (for 380～460Vac Input supply)
- Overvoltage category 2 (for over 460Vac Input supply)
*3) The power supply capacity is the value of the rated output current at
440V. Impedance at the supply side changes due to the wiring,
breaker, input reactor, etc.
*4) Is necessary to set the carrier frequency settings [bb101]/[bb201]
equal or greater than the (maximum output frequency x 10)Hz. For
induction motor IM, set the carrier frequency to 2 kHz or more
except V/f control. For synchronous motor (SM), permanent magnet
motor (PMM) set the carrier frequency to 8 kHz or more.
015 022 037 055 075
2.2 3.7 5.5 7.5 11
2.2 3.7 5.5 7.5 11
1.5 2.2 3.7 5.5 7.5
5.4 8.3 12.6 17.5 25.0
4.8 6.7 11.1 16.0 22.0
4.0 5.5 9.2 14.8 19.0
Three-phase(3 wire)380～500V (Corresponding to the incoming voltage)
3.7 5.8 8.7 12.1 17.3
3.3 4.6 7.7 11.1 15.2
2.8 3.8 6.4 10.3 13.2
4.7 7.2 10.9 15.2 21.7
4.2 5.8 9.6 13.9 19.1
3.5 4.8 8.0 12.8 16.5
6.4 9.9 15.0 20.8 29.8
5.7 8.0 13.2 19.0 26.2
4.8 6.5 11.0 17.6 22.6
Control power: Single-phase supply 380～460V (+10%, -15%), 50Hz/60Hz(±5%)
Main circuit power supply: Three-phase(3 wire) 380～460V (+10%, -15%), 50Hz/60Hz(±5%)
4.9 7.5 11.4 15.9 22.7
4.4 6.1 10.1 14.5 20.0
3.6 5.0 8.3 13.4 17.2
Internal BRD circuit (external discharge resistor value)
100 100 70 70 35
255 255 255 260 260
150 150 150 210 210
140 140 140 170 170
4 4 4 7 7
110 150 185 220 300
15 18.5 22 30 37
15 18.5 22 30 37
11 15 18.5 22 30
31.0 40.0 47.0 62.0 77.0
29.0 37.0 43.0 57.0 70.0
25.0 32.0 39.0 48.0 61.0
110% 60sec / 120% 3sec
120% 60sec / 150% 3sec
150% 60sec / 200% 3sec
21.5 27.7 32.6 43.0 53.3
20.1 25.6 29.8 39.5 48.5
17.3 22.2 27.0 33.3 42.3
26.8 34.6 40.7 53.7 66.7
25.1 32.0 37.2 49.4 60.6
21.7 27.7 33.8 41.6 52.8
36.9 47.6 56.0 73.8 91.7 110.7 138.1 175.0 209.5 253.6 300.0 376.2
34.5 44.0 51.2 67.9 83.3 101.2 125.0 160.7 190.5 232.1 273.8 345.2
29.8 38.1 46.4 57.1 72.6
28.1 36.3 42.6 56.3 69.9
26.3 33.6 39.0 51.7 63.5
22.7 29.0 35.4 43.5 55.3
0.5～10.0kHz
0.5～12.0kHz
0.5～16.0kHz
200%/0.3Hz
35 24 24 20 15
260 390 390 390 540
210 245 245 245 300
170 190 190 190 195
IP20 – UL Open Type
7 16 16 16 22
*5) The values for the sensorless vector control are assigned according
to the values in the ND rating of the Hitachi standard motor table.
Torque characteristics may vary by the control system and the use of
the motor.
*6) The key height of keypad are exclued from dimensions. When an
option is connected, the dept neccesary is increased. Refer to the
each optional instruction. *7) Usually is required an external
regenerative braking unit. However, with an optional built –in
chopper braking ciruit and external discharge resistor can eliminate a
external regenerative unit. The built-in chopper braking circuit is
offered by order. In order to purchase, contact to the distributor.
7-1
Specifications
370 450 550 750 900
45 55 75 90 110
45 55 75 90 110
37 45 55 75 90
93.0 116 147 176 213
85.0 105 135 160 195
75.0 91.0 112 150 180
64.4 80.4 101.8 121.9 147.6 174.6 218.9
58.9 72.7 93.5 110.9 135.1 159.3 200.9
52.0 63.0 77.6 103.9 124.7 150.3 180.1
80.5 100.5 127.3 152.4 184.5 218.2 273.7
73.6 90.9 116.9 138.6 168.9 199.2 251.1
65.0 78.8 97.0 129.9 155.9 187.9 225.2
89.3 108.3 133.3 178.6 214.3 258.3 309.5
84.4 105.2 133.4 159.7 193.2 228.6 286.7
77.1 95.3 122.5 145.2 176.9 208.7 263.1
68.0 82.6 101.6 136.1 163.3 196.9 235.9
0.5～8.0kHz
0.5～8.0kHz
0.5～10.0kHz
180%/0.3Hz
*6) Ext. regen. braking unit
15 10 10
- -
550 550 550 700 700
390 390 390 390 390
250 250 250 270 270
30 30 30 55 55
1100 1320
132 160
132 160
110 132
252 316
230 290
217 260
- -
740 740
480 480
270 270
70 70