..................4 MOUNTING THE ILLUMINATOR ....................5 MOUNTING THE BRIDGE ..............5 MOUNTING THE TRINOCULAR VIEWING HEAD ..............5 MOUNTING THE BINOCULAR VIEWING HEAD ..................6 ATTACHING THE LED POINTER MAINTENANCE........................7 SERVICE ..........................7 WARRANTY ......................... 7 ® ACCU-SCOPE...
Your ® microscope will last a lifetime if used and maintained properly. ACCU-SCOPE microscopes are carefully assembled, inspected and tested by our staff of trained technicians in our New York facility.
Insert the end of the power cord from the illuminator housing into the base of the microscope as shown in (Fig. 2); tighten the locking ring by turning it clockwise until it stops. Locking ring Fig. 2 The illuminator assembly is complete (Fig. 3). Fig. 3 ® ACCU-SCOPE...
(On other side) Mounting the Binocular Head (Fig. 6) Carefully attach the binocular head as shown (Fig. 5) to the rear of the microscope bridge. Using the Fig. 6 enclosed 2.5mm Allen wrench, tighten the lock screw by turning clockwise. ® ACCU-SCOPE...
Insert the round end of DC 5 volt plug of the LED Pointer into the DC 5 volt outlet on the microscope (Fig. 7). Insert the power cord plug into a standard 120 volt electrical outlet. DC 5 Volt Plug Fig. 7 Assembly is complete (Fig 7.). ® ACCU-SCOPE...
864-1000. This warranty is limited to the continental United States of America. All items returned for warranty repair must be sent freight prepaid and insured to ACCU-SCOPE INC., 73 Mall Drive, Commack, NY 11725 – USA. All warranty repairs will be returned freight prepaid to any destination within the continental United States of America, for all foreign warranty repairs return freight charges are the responsibility of the individual/company who returned the merchandise for repair.