Multi Tool Safety Warnings - Crown CT16004 Original Instructions Manual

a) Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.

2.MULTI TOOL SAFETY WARNINGS

1. This power tool is intended to function for sawing, cutting, grinding and
sanding. Read
specifications provided with this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury.
2. Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
3. Use clamps or another practical way to secure and support the workpiece to
a stable platform. Holding the work by hand or against your body leaves it unstable
and may lead to loss of control.
4. Position the cord clear of the spinning accessory. If you lose control, the cord
may be cut or snagged and your hand or arm may be pulled into the spinning
accessory.
5. Always use safety glasses or goggles. Ordinary eye or sun glasses are NOT
safetyglasses.
6. Avoid cutting nails. Inspect workpiece for any nails and remove them before
operation.
7. Hold the tool firmly.
8. Make sure the application tool is not contacting the workpiece before the
switch is turned on.
9. Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool. only when hand-held.
11. Always switch off and wait for the blade to come to a complete stop before
removing theblade from the workpiece.
12. Do not touch the application tool or the workpiece immediately after
operation; they may be extremely hot and could burn your skin.
13. Do not operate the tool at no-load unnecessarily.
14. Always use the correct dust mask/respirator for the material and
application you are working with.
15. Some material contains chemicals which may be toxic. Take caution to
prevent dust inhalation and skin contact. Follow material supplier safety data.
16. This tool has not been waterproofed, so do not use water on the workpiece
surface.
17. Ventilate your work area adequately when you perform sanding operations.
18. Use of this tool to sand some products, e.g.leaded paint surfaces, wood
and metals could expose user and bystanders to dust containing hazardous
substances. Use appropriate respiratory protection.
19. Be sure that there are no cracks or breakage on the pad before use. Cracks
or breakage may cause a personal injury.
20. Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can be
all safety warnings, instructions,
EN
3
illustrations and