Table of Contents
Advertisement
Installation
Rear wall cut-out – without drilling template
Ideally, the drilling template supplied with the appliance should be used. The fol-
lowing instructions should only be used if the drilling template is not available.
Surface-mounted installation
View of the drilling template side 2. Not to scale.
Measure the thickness of your worktop (C).
Determine the midpoint of the longest side of the cut-out.
Mark the point that is 177.5 mm (A) to the right of the midpoint.
Mark the point (D) that is (123 mm – C (thickness of the worktop)) below the right
end of distance A.
Saw a hole with a diameter of 146–150 mm around this point.
Plug&Play mode only: engage the Plug&Play adapter in position 2.
96
Advertisement
Table of Contents
