Siemens RDG20 KN Series Basic Documentation page 57

Set Time / date
Note
A6V11545892_en--_c
– Fan speed: The manual fan is below or equal to the auto fan speed value
– Operating mode: The manual mode is lower or equal to the scheduler
mode
● Red leaf: The settings exceed the preset energy-efficiency range
P110 configures the green leaf function:
● 0 = Disabled (OFF)
● 1 = Green and red dimmed down
● 2 = Green dimmed down / red fixed
● 3 = Green and red fixed
Energy-efficient setting
Set TIME
WARNING
Time synchronization via bus
Time of day and date information are received from a Synco controller with time
master function (RMB, RMB, OWZ, etc) or any other KNX device e.g. GPS clock
if the corresponding communication object is bound.
The scheduler function must be enabled before setting the time of day:
●
Press once and then turn the rotary knob or press
select programming mode TIME.
●
Press once and then turn the rotary knob to select the time format.
●
If 12H is selected, press
PM.
●
Press once and enter the hour setting.
●
The hour value flashes and can be changed by turning the rotary knob.
●
Press once to confirm the adjusted value and enter the minutes setting.
Repeat the steps as for the hour.
When time format is 24 h, AMPM is not displayed.
Exceed the preset energy-efficient
range
Touch to reset user setting
once and then turn the rotary knob to select AM or
Functions
4
Additional functions
continuously to
57 | 180