Operating Guide | Custom Bench Scale Specifications 7600 Digital Weigh Indicator ENCLOSURE: Stainless Steel, NEMA 4X DIMENSIONS: 9” W x 6.25” H x 4” D LOAD CELL A/D CONVERTER: 24 bit delta sigma, 16 mv signal input EXCITATION: 5 VDC, 120 mA max.
Operating Guide | Custom Bench Scale QUICK START CONFIRM ALL COMPONENTS & ESTABLISH LOCATION OF USE IMPORTANT! Precision bench scales can be adversely affected by ambient conditions. Take care to avoid environmental conditions such as mechanical vibrations, blowing air, electro-mechanical noise, magnetic forces and spikes in the 120V AC supply source.
Page 6
Operating Guide | Custom Bench Scale QUICK START CONNECT THE WEIGHING PLATFORM 1) Connect cable from the weighing platform/load cell to the socket labeled “LOAD CELL” on the back of the digital indicator; hand tighten the threaded collar. CONNECT PERIPHERALS 2) Connect bar code scanner to the short cable labeled “SCANNER”...
The scanner will beep and “Id.SCAn” will display, confirming the scan. PRINTING LABELS Press the PRINT key on the 7600 model digital weight indicator to print out the custom configured label from the TSP700ii thermal label printer. QS-4...
• Check all cables & cable connectors • Check AC adapters (meter output) • Check 120V AC power sources TECHNICAL SUPPORT Triner Scale provides toll-free telephone technical support to original purchasers of our products. Tech support can be reach Mon-Fri 8:00 AM ~ 4:30 PM. QS-5...
Operating Guide | Custom Bench Scale Keypad Keys Functions ZERO Key - Sets the scale to zero. UNITS – Switches the scale bet ween the primary w eighing unit & secondary weighing unit. PRINT - Transmits formatted print to any device connected to the RS-232 port.
Page 11
CAUTION! Parameters, programming codes and calibration of all components are set at the factory. Making any changes to settings will affect the system’s operation! Contact Triner Scale (800) 238-0152 technical support for information related to parameters, programming and calibration of components.
Need help?
Do you have a question about the 7600 and is the answer not in the manual?
Questions and answers