Table of Contents
Advertisement
RouteFinder-T1 User Guide
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software must be installed and functional before the configuration program can be used.
1.
You must assign an Internet (IP) address for the PC and for each node that will be managed by
the configuration program. Refer to the protocol software documentation for instructions on how to
set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for the
PC host name. You should also test the network interface configuration by Pinging another TCP/IP
device that is connected to the network.
2.
Install the RouteFinder software on the local PC. When installed click Start | Programs |
RouteFinder | Configuration Port Setup, or double-click on the Configuration Port Setup icon
in the RouteFinder program group.
3.
The RouteFinder Port Setup dialog box is displayed.
Verify that the Communication Type field is set to IP.
In the Router IP Address field, enter the IP Address of the remote RouteFinder.
Click OK when you are satisfied with your selections.
4. The Windows Program Manager menu is displayed.
Double click the RouteFinder Configuration icon.
5. The Reading Setup dialog box is displayed.
46
MTASR2-203
Advertisement
Table of Contents
