Step 2: Install The Mounting Hardware - IBM Ethernet Appliance J34S Getting Started Manual

IBM Ethernet Appliance J34S Getting Started Guide

Step 2: Install the Mounting Hardware

The specific mounting hardware required depends on the type of rack being used.
Use the appropriate procedure steps to install the mounting hardware for your
situation.
To install the mounting hardware:
1.
2.
Figure 3: Attaching Mounting Hardware for Two-Post Rack
Figure 4: Attaching Mounting Hardware for Cabinet or Four-Post Rack
6
Step 2: Install the Mounting Hardware
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic discharge (ESD) wrist strap (provided)
Locate the rack mount brackets in the accessory kit.
Use the screws provided to secure the rack mount brackets to the sides of the
chassis:
For a two-post rack, mount the brackets at the mid-mount holes as shown
in Figure 3 on page 6.
For a four-post rack, mount the brackets near the front edge of the chassis
as shown in Figure 4 on page 6.