Multitech MultiVOIP MVP100GK Gatekeeper User Manual page 11

The Command Modem is built into the Gatekeeper unit. To configure the Gatekeeper remotely using its Windows
GUI, you must call into the Gatekeeper's Command Modem. Once a connection is made, the configuration
process is identical to local configuration with the Windows GUI.
5. Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded when
mounted within a rack.
This can be accomplished by connecting a grounding wire between the chassis grounding screw (see
Figure 3-9) and a metallic object that will provide an electrical ground.
6. Turn on power to the Gatekeeper by setting the power switch on the right side panel to the ON position.
Wait for the Boot LED on the Gatekeeper to go off before proceeding. This may take a couple of minutes.
Proceed to Loading Gatekeeper Software section.
Multi-Tech Systems, Inc. MultiVOIP Gatekeeper User Guide
Figure 2-2. GND & Remote Config Modem Connections
Chapter 2 – Installation
11