Ignition Unit - BRP ROTAX FR 125 MAX Repair Manual

Ignition unit

Note: Ignition timing is controlled by the digital
battery ignition unit consisting of the
trigger coil on the crankcase and an
ignition coil with the integrated
electronic. Manual ignition adjustment
is neither required nor possible.
Components:
1 trigger coil (pick up)
2 ignition coil
3 wiring harness
4 resistance spark plug connector
5 spark plug
6 on/off circuit breaker ( automatic fuse )
7 start button
8 battery
9 battery charger
10 electric starter assy
11 starter reduction gear assy
12 reduction gear cover
Note: If the engine will not start and if the ignition unit does not generate the
ignition spark or at indications that malfunctions of engine are caused by
the ignition unit verify the following components in the stated sequence or
trace error by method of elimination:
check the battery charge, if necessary charge the battery or exchange it for a fully
charged one
verify all plug connections and cable harness for good condition.
in case of doubt replace the cable harness
replace the spark plug
replace the resistance spark plug connector
replace the on/off circuit breaker (automatic fuse)
replace the start button
replace the trigger coil ( pick up )
replace the ignition coil
Page 38
Repair Manual FR 125 MAX and FR 125 Junior MAX
8
2
3
6
9
4
5
10
11
12
1
Figure 51
Edition 11/2000
7