SolidRF MobileForce Manual page 10

Trouble Shooting: No Signal Improvement
Step 1. Check power. Ensure the indoor
unit is plugged in and the LED Power
Light is green.
Step 3. If any of the lights on the front panel are flashing in green then off/continue
flashing/solid green, it means that self oscillation is occurring. You must switch off the
booster and check the outside and inside antennas' seperation immediately. Make sure
that the Minimum Separation Requirements have been met.
Horizontal distance: 3 ft (1 meters), Vertical distance: 2 ft (0.6 meters)
≥2 feet
Step 2. Check incoming signal level at outdoor
antenna position. Usage of a booster is not
recommend when the outside signal is less
than -110dbm(3G/1x) or -120dBm(4G/LTE).
≥3 feet
10