DROID TURBO 2 / Moto X Force
Level 2 – Service and Repair Manual
1.
Place the PCB into the Bounce PCB Assembly
Fixture (3-00-D7-10000).
2.
Remove the PCB Shield Copper Tape from the
carrier.
3.
Place the PCB Shield Copper Tape into the
fixture over the PCB, using the pins in the fixture
to align it.
4.
Press down on the PCB Shield Copper Tape for
5 seconds to secure it to the PCB Shield.
5.
Remove the PCB from the fixture.
6.
Remove the remaining liner from the PCB Shield
Copper Tape.
7.
Use the Blackstick to adhere the edges of the
PCB Shield Copper Tape to the PCB Shield.
PAGE 79
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola