Revision History - Lenovo motorola DROID TURBO 2 Service And Repair Manual

DROID TURBO 2 / Moto X Force
Level 2 – Service and Repair Manual
R H
EVISION ISTORY
Revision Date
1 10/30/2015
2 12/04/2015
3 01/28/2016
PAGE 2
Notes
Initial release.
Bounce Chassis Screw Guide (3-00-F6-10000) added to Tools Required for
Assembly and Battery Assembly.
• Figure 8 updated to include the DROID Logo.
• Table 3 updated to include rework Audio Bezels and the DROID Logos.
• Audio Bezel and DROID Logo added to Disassembly and Recovery Map.
• Bounce Inlay Heating Plate (3-00-F5-10000) and "7x7" Hot Plate
(4-00-Z2-10000 (220V) /4-00-Z3-10000 (110V)) added to the Tools Required
for Disassembly.
• The Rear Inlay Removal section was updated to include pre-heating
instructions using the Bounce Inlay Heating Plate (3-00-F5-10000).
• The following sections were added to Disassembly and Recovery:
o Audio Deco Removal
o DROID Logo Removal
o Side Key Removal
• DROID Logo added to Assembly Map.
• The Tools Required for Assembly section was updated to include the new
Bounce Audio Bezel Press Tool (3-00-F7-10000) and an updated image of the
Bounce Earpiece Deco Press Fixture (3-00-D8-10000).
• The Rear Inlay Assembly section was updated to include assembly of the
DROID Logo.
• The Audio Deco Assembly section was updated to include rework Audio
Bezels, updated images of the Bounce Earpiece Deco Press Fixture (3-00-D8-
10000), and the new Bounce Audio Bezel Press Tool (3-00-F7-10000).
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola