Table of Contents
Advertisement
DROID TURBO 2 / Moto X Force
Level 2 – Service and Repair Manual
1.
Place the Inlay Adhesive into the Bounce Inlay
Adhesive Fixture (3-00-E8-10000), using the pin
in the fixture and the deco hole in the adhesive
to align it.
2.
Remove the adhesive liner from the Inlay
Adhesive.
3.
Place the Rear Inlay into the fixture over the
Inlay Adhesive, using the pin in the fixture and
the deco hole to align it.
4.
Apply manual pressure to the Rear Inlay as
follows:
Place both thumbs on point 1 and slide
•
them out to point 2.
Place both thumbs on point 3 and slide
•
them out to point 4.
Place both thumbs on point 5 and slide
•
them out to point 6.
Place both thumbs on point 7 and slide
•
them out to point 8.
Place both thumbs on point 9 and slide
•
them out to point 10.
Place both thumbs on point 11 and slide
•
them out to point 12.
5.
Remove the Rear Inlay from the fixture.
6.
Place the Rear Inlay on a flat surface.
PAGE 126
11
12
9
10
1
2
3
4
5
6
7
8
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
12
10
2
4
6
8
Advertisement
Table of Contents
