Replacing An Expansion Module Of Sg-6000-X8180; Replacing An Scm - Hillstone SG-6000-X Series Hardware Reference Manual

Notes: If you do not want to install a new module, apply a blank plate over the slot
to avoid dust falling into the chassis.

Replacing an Expansion Module of SG-6000-X8180

Replacing an SCM

To replace an SCM, take the following steps:
1. Wear an electrostatic discharge (ESD) strap around your bare wrist and connect the strap to
an ESD point on the chassis. See
2. Use a cross screwdriver to loosen SCM screws until they pop out.
3. Hold the screws and pull the SCM straight out of the chassis, as shown below.
4. Put the removed module into an antistatic bag or on a flat antistatic table.
5. Install a replacement module (see
Notes: If you do not want to install a new module, apply a blank plate over the slot
to avoid dust falling into the chassis.
193
ESD Prevention.
Installing an SCM).
Chapter 5 Hardware Maintenance and
Replacement