Table of Contents
Advertisement
Session Key
Spread Factor
If ADR is disabled, the device will send data via this spread factor.
If the device does not receive ACK packet from network server, it will resend
Confirmed Mode
data 3 times at most.
Reporting interval ≤ 30 mins: the device will send specific amount of
LoRaMAC packets to check connection status every 30 mins; If there is no
reply after specific amount of packets sent, the device will re-join.
Rejoin Mode
Reporting interval > 30 mins: the device will send specific amount of
LoRaMAC packets to check connection status every reportinginterval; If there
is no reply after specific amount of packets sent, the device will re-join.
ADR Mode
Allow network server to adjust datarate of the device.
Tx Power
Transmit power of the device.
RX2 Data Rate
RX2 data rate to receive downlinks.
RX2
RX2 frequency to receive downlinks.
Frequency/MHz
Note:
1) Please contact sales for device EUI list if there are many units.
2) Please contact sales if you need random App keys before purchase.
3) Select OTAA mode if you use Linovision IoT cloud to manage devices.
4) Only OTAA mode supports rejoin mode.
LoRaWAN Frequency Settings:
Go to "Settings ->LoRaWANSettings" of ToolBox App to select supported frequency and select
channels to send uplinks.Make sure the channels match the LoRaWAN
®
gateway.
10
Advertisement
Table of Contents
