Related Manuals for Multitech CallFinder CF100FX2
Summary of Contents for Multitech CallFinder CF100FX2
- Page 1 CallFinder® CDMA & GSM Cellular Gateways Configuration Guide for Inter-Operation between CallFinder Cellular Gateways and AltiGen IP Phone System...
- Page 2 Furthermore, Multi-Tech Systems, Inc. reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of Multi-Tech Systems, Inc. to notify any person or organization of such revisions or changes. Check Multi-Tech’s Web site for current versions of our product...
-
Page 3: Network Topology
Software – AltiWare 5.1 Update1 and AltiWare 5.0A with Update 4 or above. AltiWare 5.1 support dynamic trunk sharing for MobileExt operation while AltiWare 5.0A requires dedicated trunk channels to support MobileExt. Hardware – Triton or MAX1000 analog trunk port for Multi-Tech CF100FX2-G (GSM one port) and CF100FX2-C (CDMA one port) CallFinder: Software –... - Page 4 CallFinder Configuration Guide: AltiGen IP Phone System Setting Up CallFinder Hardware Please follow the steps documented in Multi-Tech’s CallFinder Quick Start Guide or CallFinder User Guide to connect the following: 1. SIM Card, if using GSM service 2. Antenna 3. Power 4.
- Page 5 CallFinder Configuration Guide: AltiGen IP Phone System Configuring AltiServ 1. Use the default analog trunk port setting to connect to the CallFinder Cellular Gateway. • Interface: Loop Start • Impedance: 600 ohm • Incoming Ring: Single Ring • Caller ID Receiving: FSK •...
- Page 6 CallFinder Configuration Guide: AltiGen IP Phone System 6. After system startup, double-click on the MobileExt virtual board and channel group to see the Mobile Extension Board Configuration. 7. Check both Use * to Simulate “FLASH” and Use ** to Disconnect and then Get Dial Tone options.
- Page 7 CallFinder Configuration Guide: AltiGen IP Phone System To set up a mobile extension 1. Open the Extension Configuration window. 2. To assign an extension to a mobile extension port, select a virtual extension and change it to a physical extension. 3.
Need help?
Do you have a question about the CallFinder CF100FX2 and is the answer not in the manual?
Questions and answers