Parameter
dIS.2
InP.2
dIS.3
InP.3
diS.4
InP.4
diS.5
InP.5
I.tYP: Impulse signal
The impulse input can be controlled in three different modes.
Active TTL signals with approx. 0.8 V lower and approx. 2 V upper threshold.
ttL
Passive switching contact that switches the internal pull up to ground.
nPn
Active sensor output. A pulldown is switched in the display.
PnP
Namur output. Low <1,5 mA, High > 2,5 mA
nAM
rAnG: Selection of the frequency range
Here you can choose from four different frequency ranges.
0...9,999 Hz (automatic software filter on 100 Hz/5ms)
9.999
0...99,99 Hz (automatic software filter on 500 Hz/5ms)
99.99
0...999,9 Hz
999.9
0...9999 Hz (approximate 10 kHz)
9999
Selection option
to
to
to
to
to
to
to
to
21
6. Parameterization
Default