Table of Contents
Advertisement
Parameter
SPC.A
dIS.1
InP.1
dIS.2
InP.2
dIS.3
InP.3
dIS.4
InP.4
diS.5
InP.5
End / OFFS: Measuring range end value / measuring range start value
With this pair of values the desired display value is assigned to the measuring signal.
If Sen.V or Sen.A was selected as input variant, you can choose between noCA and CAL. With
noCA the previously set display value is taken over, with CAL the adjustment is carried out via the
measuring section and the analog input value is taken over.
dot.A: Decimal point / Decimal place
The decimal point is used to define the decimal representation of the display value. This is also
used for setting the limit values.
EndA / OFFA: Rescaling the measurement input values
With this function the final value / initial value can be rescaled to e.g. 19.5mA / 3.2mA without
applying the measuring signal.
tArA: Setting the tare value / offset value
The preset value is added to the linearized value. This allows the characteristic curve to be
shifted by the selected amount.
ZErO: Zero point calming
With zero point calming, a range of values around the zero point can be preselected at which the
display shows a zero. If, for example, a 10 should be set, the display would show a zero in a
value range from -10 to +10 and continue with -11 below and +11 above.
Selection option
to
to
to
to
to
to
to
to
to
to
to
17
6. Parameterization
Default
Advertisement
Table of Contents
