Table of Contents
Advertisement
4. Functional description and operation / 5. Setting the display
4.2. Programming via configuration software PM-TOOL:
Part including the software on CD, is a USB cable with device adapter. The connection is
established via a 4-pin micromatch connector on the back of the device and to the PC side with a
USB connector.
System requirements: PC with USB interface
Software: Windows XP, Windows VISTA
With this tool the device configuration can be generated, omitted and saved on the PC. Through
the easy-to-use program interface, the parameters can be changed, whereby the mode of
operation and the possible selection options are specified by the program.
ATTENTION!
When setting parameters with a measuring signal connected, make sure that the measuring
signal does not have a ground reference to the programming plug.
The programming adapter is not galvanically isolated and is directly connected to the PC.
Reversing the polarity of the input signal can cause a current to flow through the adapter and
destroy the device and connected components!
5. Setting the display
5.1. Switch on
After completing the installation, you can put the device into operation by applying the supply
voltage. Before doing so, check all electrical connections once again to ensure that they are
correctly connected.
Start sequence
During the switch-on procedure, the segment test (8 8 8 8), the message of the software type and
afterwards for the same time the software version are displayed for 1 second. The start sequence
is followed by the change to the operating or display mode.
14
Advertisement
Table of Contents
