Multitech MultiVOIP MVP810 Install Manual page 2

Technical Configuration Procedure
1. Turn on the power of the MVP-410/810-CF unit and wait for the boot light to go out.
2. The Command Cable has a DB25 connector at one end and it connects to the Command port on the MVP
unit. The other end is a DB9 connector and it connects to the computer you are using to configure the
MVP unit.
NOTE: Because USB-to-Serial adapters sometimes cause problems, we recommend using a
standard built in DB9 serial port when available.
3. Install the MultiVOIP software on the computer that you'll use to configure the MVP unit. You will be
asked to designate an available COM port on your PC that your PC will use to communicate with the
MVP unit. When prompted to 'Do you want to run the MultiVOIP configuration', click Yes.
4. After the configuration of the MVP unit has been read into the PC, the Status at the bottom right corner of
the screen will be "Rights: Read/Write."
5. In the MultiVOIP software, go to
a. Enter IP Address.
b. Enter IP Mask.
c. Enter Gateway IP.
d. Click OK.
6. In the MultiVOIP software, go to
a. In the Selected Coder field, choose "G.711 u-law."
b. In the
Advanced Features
c. Click on the Copy Channel button. When the Copy Channel screen appears, click "Copy to All."
7. In the MultiVOIP software, go to
configuration to all odd-numbered channels. Then you will configure Channel 2 and copy its configuration
to all even channels.
a. Set the Interface Type field to "DID/DPO."
b. In the DID Options field group, set the Start Modes field to "Wink Start."
c. Click on the Copy Channel button. When the Copy Channel screen appears, select the odd
channels (3, 5, and 7). Click Copy. Click OK.
d. In the Interface Parameters screen, in the Select Channel field, select "Channel 2."
e. Set the Interface Type field to FXS or FXO.
If the channel is connected to a line port of a PBX, set the channel to FXS.
If the channel is connected to the analog station port of a PBX, set the channel to FXO.
f. Click on the Copy Channel button. When the Copy Channel screen appears, select the even
channels (4, 6, and 8). Click Copy. Click OK.
CallFinder on MultiVOIP Platform README Document
|
Configuration Ethernet/IP
|
Configuration Voice/Fax
group, uncheck "Silence Compression."
|
Configuration Interface
.
.
. You will configure Channel 1 first and copy its
Page 2 of 4