Electrical Connection; Commission - unicraft TWG 1 Operating Instructions Manual

Fig. 5: Assembly Part Washing UnitTWG 1

7.2 Electrical connection

DANGER!
Danger of life by electrical current!
There is an immediate danger of electrocution on
contact with live components.
- Work on the electrical system only by electricians.
ATTENTIOM!
The Part Washing Unit must have a good grounding
to avoid static electricity and sparking
Step 1: Check whether the mains voltage corresponds to
the voltage indicated on the rating plate.
Step 2: Ensure a good grounding of the parts washing
device.
Step 3: Connect the power cord to the mains.
TWG 1 | Version 1.02
8
There is danger to your life if you do not follow these
rules.
- Never work on the Part Washing Unit if you are un-
- The Part Washing Unit may only be operated by one
suction tube
Step 1:Before startup, fill the tank with at least 4 liters of
Step 2: Connect a compressor with a hose diameter 8 to
Fig. 6: Air supply Part Washing Unit TWG 1

Commission

WARNING!
Danger of life!
der the influence of alcohol, drugs or medicines and
/ or you are overtired or suffer from concentration-
impairing illnesses...
person. Other persons must keep away from the
work area during operation.
Use ear protection!
Use safety goggles!
Use respiratory protection!
Use safety boots!
Use protective clothing!
solvent. The maximum tank capacity is 9 liters.
Fill the solvent about 20 mm higher than the aspi-
ration. To check this, it is possible to pull out the
tank and read the level gauge.
the bottom of the parts washing device (Fig. 6).
Commission
Air supply
9