Table of Contents
Advertisement
9
Care maintenance and repair
ATTENTION!
Disconnect the tool from the compressed air supply
and the Part Washing Unit from the mains before
carrying out any maintenance, servicing and cleaning
work. Maintenance and repair work may only be car-
ried out by qualified personnel.
9.1 Care by Cleaning
The Part Washing Unit should always be kept in a clean
condition.
Use safety gloves!
NOTE!
Never use harsh detergents for cleaning. This can
lead to damage or destruction of the device
All plastic parts and painted surfaces should be cleaned
with a soft, damp cloth and some neutral detergent.
Keep the tool clean and dry.
9.3 Troubleshooting
ATTENTION!
If any of the following errors occur, immediately stop
working with the Part Washing Unit. It can cause
serious injury or damage to the tool. All repairs or
replacement work must only be carried out by quali-
fied and trained personnel. The tool must first be dis-
connected from the compressed air source.
Fault
Wash gun works only with compres-
sed air and not with detergent
Interior lighting in the parts washing
device does not work
Fan in the parts washing machine
does not work
TWG 1 | Version 1.02
9.2 Maintenance and repair
Maintenance and repair work may only be carried out
by qualified personnel.
If the Part Washing Unit does not work properly, contact
a dealer or our customer service. The contact details can
be found in chapter 1.2 Customer Service.
All protection and safety equipment must be reinstalled
immediately after completion of repair and maintenance
work.
The air hoses should be checked at regular intervals for
damage and leaks. The damaged hoses must be re-
placed.
Clean the tool regularly from dirt. Regular cleaning
makes working with the pneumatic tool easier.
Possible cause
1. Lever for cleaning agent is swit-
ched off
2. Too little detergent in the tank
3. Intake pipe is blocked
Illuminant defective
Fan is defective
Care maintenance and repair
ATTENTION!
Remedy
1. Switch on the lever for cleaning
agent
2. Fill tank with cleaning agent
3. Clean the intake pipe
Replace bulbs
Replace fan
11
Advertisement
Table of Contents
