Contents Contents About this document Function ........................... 3 Target group ........................3 Symbols used........................3 For your safety Authorised personnel ....................... 4 Appropriate use ........................ 4 Safety instructions for Ex areas ..................4 Environmental instructions ....................4 Product description 3.1 Configuration ........................
1 About this document About this document Function This operating instructions manual provides all the information you need for mounting, connection and setup of the instrument. Further- more there are important instructions for maintenance, fault rectifica- tion, the exchange of parts and the safety of the user. Please read this information before putting the instrument into operation and keep this manual accessible in the immediate vicinity of the device.
2 For your safety For your safety Authorised personnel All operations described in this operating instructions manual must be carried out only by trained specialist personnel authorised by the plant operator. During work on and with the device the required personal protective equipment must always be worn.
3 Product description Product description 3.1 Configuration Scope of delivery The scope of delivery encompasses: • Electronics module VEGACAL series 60 • Documentation – This operating instructions manual Principle of operation Application area The electronics module CL 60 is suitable for exchange with capacitive sensors VEGACAL series 60.
Ex approval may be used. If there is no electronics module available on site, one can be ordered from the VEGA agency serving you. The new electronics module must be loaded with the order and fac- Sensor serial number tory data of the sensor.
4 Mounting Caution: In Ex applications only one instrument and one electronics module with respective Ex approval may be used. Check the specifications on the type label. Installation procedure Installation procedure The electronics module is located in the electronics compartment. The below illustrations show the respective position of the electronics compartment in a single or double chamber housing.
Page 8
4 Mounting Fig. 3: Loosen the holding screws Electronics module Screws (2 pcs.) 5. Pull the previous electronics out with the opening levers. 6. Insert the new electronics module carefully. 7. Screw in the two holding screws and tighten them 8.
Move to "www.vega.com", "Instrument search (serial number)". After entering the serial number, the order data of the sensor are displayed. The serial number is also available directly from VEGA. Below the order data you will find "Sensor data for Service-DTM" as XML file. Load this file with "Save as" on your PC and transfer it then via PACTware and the Service DTM to the sensor.
How to proceed if a repair is necessary You can find an instrument return form as well as detailed informa- tion about the procedure in the download area of our homepage: www.vega.com. By doing this you help us carry out the repair quickly and without hav- ing to call back for needed information.
7 Dismount Dismount Dismounting steps Take note of chapters "Mounting" and "Connecting to power supply" and carry out the listed steps in reverse order. Disposal The replacement module consists of materials which can be recycled by specialised recycling companies. We have purposely designed the electronic modules to be easily separable.
8 Supplement Supplement Technical data Technical data are stated in the operating instructions manual of the respective sensor. Electronics module • VEGACAL series 60...
Page 13
Notes Electronics module • VEGACAL series 60...
Page 14
Notes Electronics module • VEGACAL series 60...
Page 15
Notes Electronics module • VEGACAL series 60...