Control Panel; Controls - Haier ESAQ406 Owner’s Manual And Installation Instruction

CONTROL PANEL

Features and appearance will vary.
This section explains how to operate this air conditioner.
IMPORTANT:
When you turn off the air conditioner, either at the control panel
or with the remote control, wait at least 3 minutes before turning
it back on. This prevents the compressor from overloading. This
3 minute delay also applies when switching from cool mode to
fan and back.
NOTE: There is a built in 3 minute delay. You may notice the
compressor might not start right away. This was designated to
protect the unit.
Do not operate your air conditioner in the Cool Mode when
the outside temperature is below 61° F (16° C). This inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
Cont rols
1. MODE
1. Press MODE until you see the indicator light come on next
to the desired setting.
2. Choose Fan, Cool, Energy save (E-Save), or Dehum.
Fan - Only the fan runs. Press FAN SPEED to select High,
Med or Quiet fan speed. The display shows the current room
temperature.
NOTE: in fan mode, the temperature cannot be set.
E-Save - In this this mode the fan runs only when cooling is
needed. The fan will run for 3 minutes after the compressor
shuts off. The fan then cycles on for 2 minutes at 10 minute
intervals until the temperature in the room is above the set
temperature. The compressor then turns back on.
Cool - Cools the room. Press FAN SPEED to select High,
Med, Quiet or Auto Cool fan speed. Press the TEMP/ TIME
v
or arrow button to adjust the temperature. The fan will run
continuously in cool mode.
Dehum - Aids in removing humidity from the room. Dehum
mode cannot be used to cool room.
NOTE: In Dehum mode, when the set temperature is close to
ambient temperature, the compressor may stop and the fan
will run in Quiet speed only.
49- 5000454 Rev. 1
FAN COOL HIGH QUIET
E-SAVE DEHUM. MED AUTO
Temp.
MODE SPEED
Time
^
ON SLEEP CLEAN FILTER
°F/°C
OFF
Hr
POWER
FILTER
TIMER
RESET
NOTE: When the air conditioner is first plugged in, the LED
display will show "88" for 3 seconds. After the air conditioner
is turned on for the first time, the display will show the
temperature 72° F and the fan will automatically set the Quiet
speed and the Mode indicator will show ENERGY SAVE.
NOTE: To switch the temperature display between Fahrenheit
(°F) and Celsius (°C), the air conditioner must be plugged in
and turned on. On the control panel on the front of the air
conditioner press the UP and DOWN button at the same time
and hold for 3 seconds. Press F/ C button on remote control to
switch between Fahrenheit (°F) and Celsius (°C).
NOTE: Each time this ENERGY STAR qualified air conditioner
is turned on, it will operate in energy save mode per the EPA
requirements. You can select any other mode to satisfy your
needs.
2. FAN SPEED
1. Press FAN SPEED until you see the indicator light come on
next to the desired setting.
2. Choose High, Med, Quiet, or Auto.
HIGH – For maximum cooling.
MED – For normal cooling.
QUIET – For minimum cooling and noise.
AUTO – Adjusts the fan speed automatically to provide ideal
cooling based on the room temperature.
5