Control Panel; Buttons - Haier HPFD11XHT Installation And User Manual

CONTROL PANEL

A
B
C

BUTTONS

A.
B. Mode
Press this button to change the operation mode.
COOL: Blue LED lights when in cooling mode.
DEHUM:
FAN: Green LED lights when in fan mode.
HEAT: Red LED lights when in heat mode (applies only to
heat and cool models).
C. Fan Speeds
There are 3 speeds in the cool and fan modes: Low,
Medium and High.
greater than 77° F, fan speed can be adjusted, otherwise
F
D
E
air conditioner.
To automatically turn on the air conditioner, set the timer
while the power control is in the OFF position.
1.
2. Press the Timer button.
3. Press the or button to change the delay start time
from 1 to 24 hours.
4. The delay start time will display on the control panel.
while the power control is in the ON position.
1. Turn on the air conditioner
2. Press the Timer button.
3. Press the or button to change the delay stop time
from 1 to 24 hours.
4. The delay stop time will display on the control panel.
To clear the timer setting.
1.
2. Press the Timer button.
3. Press the button until the timer display has been
cleared.
E. Setting the Temperature
The or buttons can be used for adjusting the timer and
temperature settings.
To set the temperature : While in the COOL mode, press
the or button to raise or lower the temperature. The
set temperature is displayed and may be adjusted. The
temperature can be set between 61° F and 89° F (Cool
mode) and 61° F to 80° F (Heat mode). After 15 seconds
the display will revert back to the room temperature.
NOTE: The temperature cannot be adjusted in the fan or
F. Display
When the red indicator light (on the right top side beside
automatically. See the "Storage" section for directions on
draining the water from the air conditioner.
NOTE: By pressing both
time, the display will toggle between Celsius and
Fahrenheit. The temperature cannot be adjusted in the
7
and buttons at the same