Table of Contents
Advertisement
40
10. TECHNICAL DATA
Type voltage
S..H1
S..HRL1
Mains frequency
Load description
Operating modes Name
Digital set points inputs (connection signals)
Relay outputs using type 1S...H RL1
Changer, contact material: AgSnO2 / Au plated
The relay can be used for low load circuits (> 5 V 20 mA), however
not if it has been pre-loaded by 230 V AC.
Maxiumum values: 250 V 6 A, 180 W, 1500 VA
Insulation strength 4 kV / 8 mm
230 Volt, 400 Volt, 500 Volt
– 57 % + 10 %;
230 Volt – 15 % + 10 %;
> 99 V with additional 24 AC/DC elektronic power
400 Volt – 15 % + 10 %;
> 172 V with additional 24 AC/DC elektronic power
500 Volt – 15 % + 10 %;
> 215 V with additional 24 AC/DC elektronic power
all models 47Hz to 63Hz;
max. frequency change 5% per half wave
ohmic load
Load signal, with digital set point = ON
1:1
all full wave (default setting)
1:2
every 2. mains full wave (DC free)
1:3
every 3. mains full wave (DC free)
1:5
every 4. mains full wave (DC free)
The Thyro-S has 2 set point inputs. The set point inputs are safely
disconnected from the mains (SELV, PELV).
Set point 1:
Logic input 0-24 V R
Set point 2:
System interface, connection from superset
automation system via optional bus module.
=6Hz;
> 3.3kΩ ON > 3 V
i
Advertisement
Table of Contents
