31
5.2.1 THYRO-TOOL FAMILY
FIG. 7 USER SURFACE THYRO-TOOL FAMILY
Thyristor Switch of the Thyro-S range can be operated and set effort-
lessly with the aid of the PC software Thyro-Tool Family.
Necessary for working with Thyro-Tool Family is that the connection
between PC and Power Controller is present (see 5.2). This makes
visual readings, parameter viewing and fault diagnosis possible. If
Thyro-S is not operated in Thyro-Tool mode, certain parameters can
be changed. In Thyro-Tool mode changes to almost all parameters
are possible.
To change over the set point a switch can be connected to the PC-
INTERFACE RS232 and X1.3. If these terminals are connected, the
digital set point of Thyro-Tool Family is active. With open terminals
the analogue set point at X2.4 is used.