Specifying The Imager's Ip Address At The Control Panel - Codonics Horizon Starter Manual

3
3
3
8
To specify the
imager's IP
address
1-12 Setting Up the Imager

Specifying the Imager's IP Address at the Control Panel

NOTE: For a simple network, you will only need to define the imager's base IP address. You
can leave all other network settings for the imager at their default values.
NOTE: For instructions on how to use the imager's control panel and menus, refer to
Chapter 2.
NOTE: After entering the base IP address, note that the imager will reboot once you exit the
menus so that the software can be properly updated with the new value.
1. At the imager's control panel, press and hold the
while holding it press the
The Main Menu with administrative options displays.
2. Use the and
.
Settings
Menu
Load/Remove Ribbon...
Custom Job Settings...
Utilities...
Test Prints...
Print From Zip Disk...
Feature Management...
Network Settings...
Configure TCP/IP network
settings
Press MENU to exit menus
key.
MENU
keys to move the selector arrow to
key, and
Network