Table of Contents
Advertisement
7. After connecting the USB cord, the
drivers for the USB connection. If the wizard offers to connect to
search for software, select "No, not at this time. " Then select "Next" to continue.
a. Select "Install the software automatically. " Then Select "Next" to continue. You do not need
to insert the Software Installation CD-ROM.
b. Select "Finish" to close the Wizard.
Note: Another set of New Hardware Wizard windows may appear after the initial USB
connection. Follow the same instructions as mentioned previously. Once completed, your USB
connection is established.
Checking Beam Alignment
As a final step in the installation process you need to check your beam alignment. You do this using the
red pointer beam.
1. Open the top door and rotate the x axis arm cover up and out of the way.
2. Place a small piece of masking tape across the 3/4" (19 mm) hole in the focus carriage (1).
Gently rub the tape around the edge of the hole so that you can see the outline of the hole
through the tape (2).
3. Power on your computer and verify that the Universal Control Panel (UCP) icon is present on
the taskbar. If not, activate it by selecting the
4. Power on the laser system by pressing the Power button on the laser system keypad.
5. With the top door open, a red target pointer will appear on the masking tape (3). The red target
pointer should appear centered, within 1/8 inch (3 mm). If not, turn off the laser system, remove
and re-install the laser cartridge and try again.
"Found New Hardware
Wizard" will open to install the
"Universal Control
Assembling Your System
"Windows
Update" to
Panel" icon on your desktop.
17
Advertisement
Table of Contents
