Cold Weather Operation; Hot Weather Operation - Porter-Cable PCC791 Instruction Manual

cleARING A jAMMed STAPle (fIG. 8)
WARNING:
and engage trigger lock-off before performing maintenance, or clearing a jammed staple.
If a staple becomes jammed in the nose piece, keep the tool pointed away from you
and follow these instructions to clear:
1. Remove battery pack from tool and engage trigger lock-off.
2. Rotate the stall release lever (6) on the tool to release the driver blade and clear the
jam. if tool is still jammed follow steps 3-9 listed below.
3. Press the pusher latch (9) and pull the magazine (8) down.
4. Tip the tool over until the staples slide freely out
of the magazine.
5. Remove bent staple, using pliers if necessary.
6. Reinsert staples into magazine (see loading the
Tool).
7. Push magazine closed until it locks into position.
8. Reinsert battery pack.
9. Disengage trigger lock-off (2), allowing the
trigger to be actuated.
WARNING:
disable itself and will require you to reset it. To do so, follow instructions on clearing
the jammed staple. Next remove battery pack and then reinsert battery pack. The tool
will now be operational.
NoTe:
Should staples continue to jam frequently in contact trip, have tool serviced
by an authorized PoRTeR-cABle service center.

cold WeATHeR oPeRATIoN

When operating tools at temperatures below freezing:
1. Keep tool as warm as possible prior to use.
2. Actuate the tool 5 or 6 times into scrap lumber before using.

HoT WeATHeR oPeRATIoN

Tool should operate normally. However, keep tool out of direct sunlight as excessive heat
can deteriorate bumpers and other rubber parts resulting in increased maintenance.
HANG Hook (fIG. 9-10)
WARNING:
servicing this tool. Failure to do so may result in serious injury.
WARNING:
pack from tool before making any adjustments, changing accessories, servicing, or
moving the tool. Such preventative safety measures reduce the risk of starting the tool
accidentally.
cAuTIoN:
When not in use, place tool on its side on a stable surface where it will
not cause a tripping or falling hazard. Some tools with large battery packs will stand
upright on the battery pack but may be easily knocked over.
The PoRTeR-cABle cordless staplers include a hang hook (10) for convenient access
and storage during use.
To reduce the risk of personal injury, disconnect battery pack from tool
If a jam occurs, the tool will
Remove staples from magazine before making any adjustments or
To reduce the risk of serious personal injury, disconnect battery
8
13