ADJUSTING PLUNGE LOCKING LEVER
You can adjust the plunge locking mechanism to compensate for wear or to
reposition lever (in locked position). To adjust:
DISCONNECT TOOL FROM POWER SOURCE.
1.
Hold the lever in the upright position (see Fig. 9). Use a phillips
screwdriver to remove retaining screw (V) Fig. 9. Continue to hold the
lever through the remaining steps.
2.
Insert a 1/8" hex wrench (not furnished) into the adjusting screw (see Fig.
10) and turn counter-clockwise approximately 1/2 turn.
3.
Move the lever to the desired position and tighten the adjusting screw.
4.
Remove the hex wrench and replace the retaining screw.
CONNECTING TO POWER SOURCE
STARTING AND STOPPING THE MOTOR
1.
Squeeze the trigger switch (A) Fig.
11 to start the motor. Release the
trigger switch to stop the motor.
2.
To allow the motor to run
continuously, press the trigger
switch (A), push the lock button (B)
Fig. 11, and release the trigger
switch.
3.
To release the lock button, squeeze
the trigger switch and release.
V
Fig. 9
OPERATION
Confirm that the switch is off and the power circuit voltage
is the same as the voltage shown on the specification
plate. Connect the machine to a power circuit.
Before starting the router make sure bit is clear of
workpiece and foreign objects. Also keep a firm grip on the
router to resist starting torque.
B
A
11
Fig. 10
Fig. 11