Porter-Cable PCC791 Instruction Manual page 5

• Use the tool only for its intended use. Do not discharge
fasteners into open air, concrete, stone, extremely hard
woods, knots or any material too hard for the fastener to
penetrate. Do not use the body of the tool as a hammer.
Discharged fasteners may follow unexpected path and
cause injury. (Figs. D, E, F)
• Refer to the Maintenance and Repairs sections for detailed
information on the proper maintenance of the tool.
• Always operate the tool in a clean, lighted area. Be sure
the work surface is clear of any debris and be careful not to
lose footing when working in elevated environments such as
rooftops.
• Do not drive fasteners near edge of material. The workpiece
may split causing the fastener to ricochet, injuring you or a
co-worker. Be aware that the staple may follow the grain of the
wood (shiner), causing it to protrude unexpectedly from the
side of the work material. Drive the chisel point of the staple
perpendicular to the grain to reduce risk of injury. (Figs. E, F, K)
• Do not drive staples onto the heads of other fasteners
or with the tool at too steep an angle. Personal injury from
strong recoil, jammed fasteners, or ricocheted staples may
result. (Fig. G)
• Always keep fingers clear of contact trip to prevent injury
from inadvertent release of the pusher (Fig. H)
• Keep hands and body parts clear of immediate work area.
Hold workpiece with clamps when necessary to keep hands
and body out of potential harm. Be sure the workpiece is
properly secured before pressing the stapler against the
material. The contact trip may cause the work material to shift
unexpectedly. (Fig. H)
• Do not use tool in the presence of flammable dust, gases or
fumes. The tool may produce a spark that could ignite gases
causing a fire. Driving a staple into another staple may also
cause a spark. (Fig. I)
• Keep face and body parts away from back of the tool when
working in restricted areas. Sudden recoil can result in impact
to the body, especially when stapleing into hard or dense
material. (Fig. J)
• Grip tool firmly to maintain control while allowing tool to
recoil away from work surface as fastener is driven.
• Choice of triggering method is important. Check the manual
for triggering options.
• When actuating the stapler, always keep tool in control.
Inaccurate placement of tool can result in misdirected discharge
of a fastener.
• Do not drive staples onto the heads of other fasteners. Strong
recoil, jammed fasteners, or ricocheted staples may result. (Fig. K)
• Be aware of material thickness when using stapler. A protruding
staple may cause injury.
5
FIG. D
FIG. E
FIG. F
FIG. G
Fig. H
FIG. I
FIG. J