Intended Use; Pressure Release Valve; Thermal Cut-Out - Titan TTB772STM Manual

Product functions
EN EN

Intended use

This wallpaper stripper TTB772STM is designated with a nominal power of
2000 Watts.
This product is intended for wallpaper stripping and can also be used for some
cleaning tasks.
The product must never be left unattended while it is connected to power supply
or cooling down.
operation and to observe all the instructions therein.

Pressure release valve

The safety cap (1) is equipped with a pressure release valve.
When the pressure inside the water tank (4) reaches its maximum level, the valve
automatically releases pressure and steam escapes from the openings on top of
the safety cap. If this happens, check that the hose is not twisted or kinked. This
will stop once pressure level inside the tank decreases to suitable levels.
WARNING: Danger of scalding. Steam may escape from the pressure
release valve during and after use.

Thermal cut-out

The water tank socket (4b) is equipped with a thermal cut-out. In the event that
the product becomes overheated due to low or no water, the thermal cut-out
automatically switches the product off. After a cooling period the product resets
and automatically switches on again.
WARNING! Disconnect the product from the power supply if the
thermal protection is activated and before removing any parts. There
is a risk of scalding with hot water / steam.
> Inspect the product for water level, possible damage, wear or foreign objects
that block the steam plate (3) / hose (5).
> Eliminate the cause and wait 15 minutes prior to plugging the product again
(see "Troubleshooting").
16
TTB772STM by TITAN