Filling With Water - Titan TTB772STM Manual

TTB772STM by TITAN
> After use, once the product has cooled down, unscrew both hose adaptors (5a)
in an anti-clockwise direction from the steam plate (3) and water tank (4) hose
connectors (3a, 4d).
NOTE: Slightly unscrew the safety cap (1), once the product has
cooled down. If it triggers a jet of steam, the water tank (4) is still under
pressure. Wait 15 minutes before checking again and attempting to
disassemble the product.

Filling with water

WARNING!
power supply and wait for 15 minutes before adding water into the
water tank (4). There is a risk of scalding with steam and / or hot
water.
The water tank (4) has a capacity of 4 liters. Fill the water tank (4) as follows:
>
stable and heat-resistant surface.
> Unscrew the safety cap (1) in an anti-clockwise direction and remove it from the
water tank (4) (Fig. 7).
> Pour water into the water tank (4) until the water level reaches between the MIN
and MAX markings on the water level indicator (4c) (Fig. 8). Use a proper funnel
MAX level.
1
4
Fig. 7
MNL_MWPS2000_DFT_MAC_ Wallpaper Stripper_GB_V1_200818.indd 13
1
4c
Fig. 8
Before you start
EN
4
13
8/18/20 3:56 PM