Installing The Unit - STIEBEL ELTRON AQ 35 E-2 Operation And Installation Instructions Manual

4. Installation Instruction

4.2 Installing the unit

1. Release cover securing screw
(Fig. 6 No.11).
2. Remove cover.
3. Determine the position of the
drill holes and drill the holes.
Insert the wall plugs and screw
in the screws (ensure screw
insertion depth is correct, Fig. 3
No.12).
4. Feed the connection cable
through the cable seal (Fig 8 No.
2) in the rear wall. Guide the
unit over the wall securing
screws and slide it downwards
(Fig.4 No.13).
5. Fit a secure connection cable
(Fig. 5 No. 10 ensure dimensions
are correct).
6. Fit the cold water connection.
Connect the water valve with
the filter (Fig. 8 No.14) and the
washer to the cold water inlet
of the unit (Fig.8 No. 6).
7. Straighten the unit and tighten
the screws.
8. Connect the electrical supply.
9. Fit the cover and secure with
the screw.
STIEBEL ELTRON
for the qualified installer
10. Turn the rotary control (Fig.1-A)
to the left and right (internal
setting lever will engage).
11. Fit the shower accessories to the
unit.
12. Flush the cold water pipe
thoroughly.
The outlet must not be
connected to any tap or fitting
other than those specified.
13