Advertisement
1. Shoulder bolt
2. Nut
Installing the New Brake Cable
1.
Secure the brake cable to the brake lever
assembly as follows:
A.
Install the brake-cable spring to the clevis
pin on the brake lever
1. Large cotter pin
2. Clevis pin
Figure 7
3. Brake lever
(Figure
7).
Figure 8
3. Brake-cable spring
B.
Slide the brake cable into the slot on the
upper-receiver weldment
Removing the Brake Cable and Lever (page
2)].
•
Ensure that the jam nut, flat washer,
and lock washer are both sides of the
bracket.
•
Adjust the jam nuts so that an equal
amount of cable threads are visible
above and below the jam nuts.
•
Leave the jam nuts snug until the final
brake-cable adjustment.
2.
Route the brake cable towards the transmission.
The cable will be installed to the transmission in
the following procedure.
6
g353220
Installing the Transmission
Parts needed for this procedure:
1
Transmission
Removing the Existing
Transmission
For instructions to remove the transmission, refer to
the Removing the Transmission Gear Box Assembly
procedure in your traction unit Service Manual.
Installing the Transmission
For instructions to install the transmission, refer to
the Removing the Transmission Gear Box Assembly
procedure in your traction unit Service Manual.
g343437
5
[Figure 4
in
3
Advertisement
