Table of Contents
Advertisement
Quick Links
Transmission Replacement Kit
Greensmaster
Model No. 140-9324
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Shut off the machine.
3.
Remove the spark-plug wire from the spark plug;
refer to your machine Operator's Manual.
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
1000 Series Mower
Description
No parts required
No parts required
No parts required
No parts required
Brake lever
Bushing
Brake cable
Clevis pin
Cotter pin
Transmission
No parts required
Register at www.Toro.com.
Qty.
–
Prepare the machine.
–
Remove the control cover.
–
Remove the brake cable and lever.
–
Modify the upper-receiver weldment.
1
2
1
Install the new brake cable and lever.
1
1
1
–
Install the control cover.
2
Removing the Control
Cover
No Parts Required
Procedure
1.
Disconnect the wire-harness connector from the
hour meter
(Figure
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3446-338 Rev A
Installation Instructions
Use
1).
*3446-338*
Advertisement
Table of Contents
Related Manuals for Toro 140-9324
Summary of Contents for Toro 140-9324
- Page 1 Form No. 3446-338 Rev A Transmission Replacement Kit Greensmaster ® 1000 Series Mower Model No. 140-9324 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
- Page 2 Removing the Brake Cable and Lever No Parts Required Procedure Remove the brake cable (Figure 3) from the brake lever shaft on the transmission gear box g280735 Figure 1 assembly as follows: 1. Wire-harness connector 2. Hour meter Loosen the front cable jam nut (Figure that secures the brake cable to the casting slot on the transmission assembly.
- Page 3 g343372 Figure 4 1. Nut 4. Jam nut 2. Brake handle 5. Brake cable 3. Shoulder bolt g343088 Figure 3 Model 04861 shown Remove the brake cable from the machine. 1. Jam nuts 4. Cable eyelet Note: You may discard the brake cable. 2.
- Page 4 Modifying the Installing the New Brake Upper-Receiver Weldment Cable and Lever Traction Units with Serial Number Parts needed for this procedure: 4080000 and Below Brake lever Bushing No Parts Required Brake cable Clevis pin Procedure Cotter pin For traction units with a serial number of 4080000 or below, remove the area of the upper receiver Installing the New Brake Lever weldment as shown in...
- Page 5 Slide the brake cable into the slot on the upper-receiver weldment [Figure 4 Removing the Brake Cable and Lever (page 2)]. • Ensure that the jam nut, flat washer, and lock washer are both sides of the bracket. • Adjust the jam nuts so that an equal amount of cable threads are visible above and below the jam nuts.
- Page 6 Installing the Control Cover No Parts Required Procedure Refer to the illustrations in 2 Removing the Control Cover (page 1) for this procedure. Use the previously-removed screws to install the control cover. Connect the wire-harness connector to the hour meter.
- Page 7 Notes:...
Need help?
Do you have a question about the 140-9324 and is the answer not in the manual?
Questions and answers