Manufacturer’s warranty ................................17 This user’s manual is a main operating document intended for technical, maintenance, and operating staff. The manual contains information about purpose, technical details, operating principle, design, and installation of the iFan Wi-Fi unit and all its modifications.
Page 3
Wi-Fi READ THE USER’S MANUAL CAREFULLY BEFORE PROCEEDING WITH INSTALLATION WORKS. COMPLIANCE WITH THE MANUAL REQUIREMENTS ENSURES RELIABLE OPERATION AND LONG SERVICE LIFE OF THE UNIT. KEEP THE USER’S MANUAL AVAILABLE AS LONG AS YOU USE THE UNIT. YOU MAY NEED TO REREAD THE INFORMATION ON THE PRODUCT SERVICING.
Page 4
Wi-Fi Precautions must be taken to avoid the back-flow of gases into the room from the open flue of gas or other fuel-burning appliances. Connection to the mains must be made through a disconnecting device, which is integrated into the fixed wiring system in accordance with the wiring rules for design of electrical units, and has a contact separation in all poles that allows for full disconnection under overvoltage category III conditions.
Page 5
Transported air must not contain any dust or other solid impurities, sticky substances, or fibrous materials. Do not use the unit in a hazardous or explosive environment containing spirits, gasoline, insecticides, etc. Do not close or block the intake or extract vents in order to ensure the efficient air flow. www.ventilation-system.com...
Page 6
Wi-Fi Do not sit on the unit and do not put objects on it. The information in this user’s manual was correct at the time of the document’s preparation. The Company reserves the right to modify the technical characteristics, design, or configuration of its products at any time in order to incorporate the latest technological developments.
Wi-Fi DELIVERY SET 1 pc. Logo 1 pc. Spigot Ø 100 mm 1 pc. Spigot Ø 125 mm 1 pc. Screws and dowels 4 pcs. User’s manual 1 pc. Packing box 1 pc. OPERATION GUIDELINES The fan is designed for connection to single-phase AC power mains 100-240 V, 50/60 Hz.
Page 8
Wi-Fi Overall dimensions Fan modifications Functions Model Humidity Turn-on Turn-off Speed Interval External Motion control hours delay timer delay timer control ventilation switch sensor iFan Wi-Fi iFan Wi-Fi Move www.ventilation-system.com...
Page 9
Wi-Fi Wi-Fi technical data Standard IEFE 802,11, b/g/n Frequency band [GHz] Transmission power [mW] (dBm) 100(+20) Network DHCP WLAN safety WPA, WPA2 Fan operation modes Standby mode – 24 hours the fan motor does not rotate, the rotation is activated when the mode is activated by a mobile application or by a signal from a temperature/humidity/motion and external switch.
Wi-Fi INSTALLATION AND SET-UP 1. In case of vertical mounting, the fan must be protected against 2. Before starting the installation, make sure all electricity has water and condensation collecting inside the fan. been turned off! Fan installation with direct air discharge upwards is not allowed.
Page 11
Wi-Fi 5. Lead the power cable to the ventilation hole, drill the mounting 6. Fix the fan with the screws. holes and install the dowels. 7. Remove the cover to access the terminal block and connect 8. Supply power to the fan.
Wi-Fi CONNECTION TO POWER MAINS The fan is rated for connection to single-phase AC power mains 100-240 V/50 (60) Hz. Terminal designations on wiring diagrams: – phase – 0 – output for external load connection – fan speed control circuit –...
Wi-Fi FAN CONTROL To start operating the fan, it is necessary to connect to it as a Wi-Fi access point with the name (FAN: + 16 characters of the ID number) Wi-Fi access point password: indicated on the control board and on the fan casing.
Wi-Fi BATTERY REPLACEMENT If the battery is low or dead, the corresponding warning indicator appears on the home page in the application (see page 16). If such an indicator appears on the home page, replace the battery. To do this, power off the fan, remove the front panel and the cover protecting the control circuit board.
Wi-Fi 3. Wash the front panel under running water. 4. Set the lock button to the working position. Wipe the front panel surface dry. Then activate the fan from the mobile application. TROUBLESHOOTING Malfunction Probable reasons Method of elimination...
Wi-Fi STORAGE AND TRANSPORTATION REGULATIONS • Store the unit in the manufacturer’s original packaging box in a dry closed ventilated premise with temperature range from +5 °C to + 40 °C and relative humidity up to 70 %. •...
Wi-Fi MANUFACTURER’S WARRANTY The product is in compliance with EU norms and standards on low voltage guidelines and electromagnetic compatibility. We hereby declare that the product complies with the provisions of Electromagnetic Compatibility (EMC) Directive 2014/30/EU of the European Parliament and of the Council, Low Voltage Directive (LVD) 2014/35/EU of the European Parliament and of the Council and CE-marking Council Directive 93/68/EEC.
Page 18
Wi-Fi by the user. • Redesign or engineering changes to the unit. • Replacement and use of any assemblies, parts and components not approved by the manufacturer. • Unit misuse. • Violation of the unit installation regulations by the user.
Need help?
Do you have a question about the iFan Wi-Fi and is the answer not in the manual?
Questions and answers