Checking For Blockages - Shark Navigator Lift-Away Pro NV390 Series Owner's Manual

CHECKING FOR BLOCKAGES

WARNING: To reduce
the risk of shock and
unintended operation,
turn power off and
unplug unit before
servicing.
TIP: You can also check
for blockages in the hose
and tubes. Just remove
floor nozzle, dust cup and
hose and shine a flashlight
in the openings.
BOTTOM OF FLOOR NOZZLE
1 Using a coin, turn locks
counterclockwise, then
open the nozzle lid to
access brushroll.
2 Tilt nozzle neck back to
straighten the airway.
Shine a flashlight from
the bottom to check for
possible blockages.
19
1-800-798-7398
STEP 1
STEP 3
STEP 2
3 Remove any string,
carpet fibers, or hair that
may be wrapped around
the brushroll. Remove
debris from brushroll. Use
scissors to carefully loosen
tangled hair or fibers.
To close the nozzle lid,
push down until it clicks
into place, then close
locks by turning them
clockwise.
STEP 1
Handle
STEP 2
HOSE CONNECTOR ON POD
1 To release hose, squeeze tabs and pull
hose out from connector.
2 To release hose from floor nozzle, squeeze
tabs and pull hose out from connector.
STEP 3
STEP 4
3 Check floor nozzle tube and remove and
blockages or debris.
4 Detach the handle from the top of the
wand and the hose from the pod. Check
openings for blockages.
s h a r kc l e a n . c o m
20