Table of Contents
Advertisement
MAINTENANCE
To keep your vacuum's
suction power optimal, follow
these instructions. Make
sure unit is off and cord is
unplugged.
WARNING: To reduce
the risk of shock and
unintended operation,
turn power off and
unplug unit before
servicing.
To prevent damage
from chemicals, rinse
filters with water only.
Allow ALL filters to air-
dry completely before
reinstalling to prevent
liquid from being drawn
into electric parts.
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
EMPTYING THE DUST CUP
XFF350
1
Clean every 3 months.
To remove the dust cup,
lift the tabs on both sides
Post-Motor Filter
of the dust cup handle. Tilt
(HEPA)
dust cup forward, then lift
XHF350
to remove.
Clean once a year.
17
1-800-798-7398
STEP 1
STEP 2
2 Hold dust cup over a trash
bin and press the lower
release button on the
bottom.
STEP 3
CLEANING THE FILTERS
1
Pre-Motor
3 To remove collected
(foam and felt):
debris from the lint screen,
press the top release
With the dust cup
removed, lift out the foam
button and lift the handle
and felt filters. Rinse
to open. Gently brush lint
filters with water only.
screen to clean.
Do not use soap. Allow
the filters to dry for at
least 24 hours before
4 To reinstall, place bottom
reinserting them into the
of dust cup into pod and
vacuum. Tap loose dirt off
then tilt it back until it
filters between washes
clicks into place.
as needed.
FOAM FILTER
FELT FILTER
HEPA
2
Post-Motor (HEPA):
To access the HEPA filter,
pull the tab under the
filter door forward. Tilt
the filter door forward to
remove it, then take out
the HEPA filter. Rinse filter
with water only. Allow it
to air-dry completely for
at least 24 hours before
reinstalling.
18
s h a r kc l e a n . c o m
Advertisement
Table of Contents
