Stairville MH-x30 LED Beam User Manual page 32

Operating
Calibration
Software version
MH-x30 LED Beam
32
Moving Head
Press [Mode] repeatedly until the display shows 'Settings' . Press [Setup]. Use [Up] or [Down] to
select the menu item 'Calibrations' and press [Setup]. Use [Up] or [Down] to enter the password
88 for the device. Press [Setup].
With [Up] or [Down] you can select one of the following calibration parameters:
'Pan' : Pan home position
n
'Tilt' : Tilt home position
n
'Gobo' : Gobo wheel start position
n
'Color' : Colour wheel start position
n
'Default' : Sets all parameters to default value 127
n
After selecting a parameter, press [Setup] and select a value between '0' and '255' .
When the display shows the desired value press [Setup] to save the setting and close the sub‐
menu. To close the submenu and the main menu without making changes, press [Mode] or
wait for 20 seconds.
Press [Mode] repeatedly until the display shows 'Settings' . Press [Setup]. The software version
of the device will appear on the display.
To close the software version display, press [Setup] or wait for 20 seconds.