Ipv6 Neighbor - H3C S3100 Series Command Manual

Command Manual (For Soliton) – IPv6 Management
H3C S3100 Series Ethernet Switches

1.1.24 ipv6 neighbor

Syntax
ipv6 neighbor ipv6-address mac-address { vlan-id port-type port-number | interface
interface-type interface-number }
undo ipv6 neighbor ipv6-address interface-type interface-number
View
System view
Parameters
ipv6-address: IPv6 address in a static neighbor entry.
mac-address: Link layer address in a static neighbor entry (48 bits long, in the format of
H-H-H).
vlan-id: VLAN ID corresponding to a static neighbor entry, in the range of 1 to 4094.
port-type port-number: Ethernet port type and port number corresponding to a static
neighbor entry.
interface-type interface-number: VLAN interface type and interface number
corresponding to a static neighbor entry.
Description
Use the ipv6 neighbor command to configure a static neighbor entry.
Use the undo ipv6 neighbor command to remove a static neighbor entry.
Note that:
You can configure a static neighbor entry in two ways:
Mapping a VLAN interface to an IPv6 address and a link-layer address. The entry
state is INCMP. After the switch get the layer 2 port information of the VLAN, the
neighbor entry enters the REACH state.
Mapping a Layer 2 port in a VLAN to an IPv6 address and a link-layer address.
The Layer 2 port specified by the port-type port-number argument must belong to
the VLAN specified by the vlan-id argument, and the corresponding VLAN
interface must exist. After you carry out the command, the device relates the
VLAN interface to the IPv6 address to uniquely identify a static neighbor entry
which is in REACH state.
You only need to specify the corresponding VLAN interface when removing a static
neighbor entry related to that VLAN interface.
Related commands: display ipv6 neighbors.
Chapter 1 IPv6 Configuration Commands
1-31