Marantz PM-10 Service Manual page 39

Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of PM10 N1G are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
↓Shooting direction: B↓
↑Shooting direction: A↑
1. AUDIO IN PCB
Proceeding : TOP COVER → SIDE PANEL → AUDIO IN PCB
(1) Remove the screws. Remove the connector. Remove the STYLE PIN.
N4508
N4506
N4505
STYLE PIN x10
(2) NOTE : Be careful of the wire configuration when assembling.
RCA PCB
・Check that the wire is in the position shown in the photo.
AUDIO IN PCB
・Check that cables ① and ② are not crossed over
・Place the two cables so that they do not pass over C3801 or C3802
・Make sure that the two cables do not touch the TOP COVER or HEAT SINK
Place the wire in this position.
39
x5 x2
x6 x6
N5010
N5009
N4507
↑Shooting direction: A↑
STYLE PIN x2
RCA PCB
qw
STYLE PIN x6 C3801 C3802
AUDIO IN PCB