Configure Snmp - HIKVISION DS-9600NXI-I8/S Series User Manual

● External Port indicates the port No. for port mapping in the router.
● The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of
the other ports should be between 1 and 65535 and the value must be different from each
other. If multiple devices are configured for the UPnP™ settings under the same router, the
value of the port No. for each device should be unique.
4. Enter the virtual server setting page of router; fill in the blank of Internal Source Port with the
internal port value, the blank of External Source Port with the external port value, and other
required contents.
Note
● Each item should be corresponding with the device port, including server port, http port,
RTSP port and https port.
● The virtual server setting interface below is for reference only, it may be different due to
different router manufactures. Please contact the manufacture of router if you have any
problems with setting virtual server.

12.4 Configure SNMP

You can configure SNMP settings to get device status and parameter information.
Before You Start
Download the SNMP software to receive device information via the SNMP port. By setting the trap
address and port, the device is allowed to send alarm events and exception messages to the
center.
Steps
1. Go to System → Network → Advanced → SNMP.
Network Video Recorder User Manual
Figure 12-3 Set Virtual Server Item
146