Table of Contents
Advertisement
6.8.
Disassembling the thermistor assy.
1. Remove the fasten terminal (CN4: blue) from the P.C.
board unit.
2. Cut the band.
3. Remove the screw A.
4. Remove the insulation plate and thermistor assy.
6.9.
Disassembling the P.C. board unit
1. Remove the fasten terminal and connector from the P.C.
board unit.
2. Remove the 4 screws G and remove the P.C. board B
assy.
3. Remove the 6 screws G.
4. Spread out the 4 holding tabs to remove the P.C. Board A
assy.
*1.The flat cable assy. is connected.
*2.Use caution not to loose the power button.
18
Advertisement
Table of Contents
