RADLEY 5125-017 Owner's Manual page 25

Keep the cutting blade sharp to ensure a good cutting performance.
3.
Replace a worn or damaged cutting blade with a new one of the same type or
have it sharpened by a qualified specialist.
Loosen the hex bolt counterclockwise using the delivered hex wrench
4.
and remove it together with the washer and the cutting blade (Fig.14).
Replace the cutting blade with a new one of the same type. Check the
5.
status of the flange onto the blade holder, then attach the cutting blade
properly, and fix it with the washer and the hex bolt. Tighten the
hex bolt clockwise with 33-44 ft lbs to ensure safe operation of your
product.
DANGER: If the cutting blade are not torqued properly, they could
become loose and be thrown from the product and seriously hurt or kill
the operator or bystanders.
Note: Replace this cutting blade after 50 hours mowing or 2 years whichever is
sooner regardless of condition. If the cutting blade is cracked or damaged, you
must immediately replace it with a new one.
Lubricate the cutting blade after each use to prolong the life span of
6.
cutting blade and product. Apply light machine oil along the edge of the
cutting blade.
GRASS CATCHER
Inspect the grass catcher before each use. Do not use it if you find any
1.
damage.
Clean the grass catcher after operation using water and mild soap.
2.
Let the grass catcher dry thoroughly before storing to avoid mildew.
3.
26
28
29
25
27
FIG.14
5125-017
24