RADLEY 5125-017 Owner's Manual page 19

1 light
(Red light ON)
/ or less
1
3
3. Release the battery status button to turn the LED's OFF.
CHARGING THE BATTERY PACK
WARNING: Charge in a safe location away from moisture and heat
sources!
Place the battery charger (Fig. 8-1) in a dry location near a 110-120V 60 Hz
1.
electrical outlet.
2. Plug the battery charger into the outlet and make sure the green LED
indicator light (Fig. 8-5) comes ON. If it does not, refer to the chart (Fig. 9) to
identify the problem.
Turn the battery pack (Fig. 8-2) upside down and slide it onto the charger (Fig. 8-1).
3.
Make sure the grooves (Fig. 8-3) in the sides of the battery slide over the
NOTE:
matching tabs on the charger (Fig. 8-4) until the battery latch "clicks" into
place.
Fig. 8
2 lights
(Red and Orange
light ON)
/ - /
1 2
3 3
3 lights
(Red/Orange/Green
ON)
-Fully charged
/
2
3
Green Red
Light Light
ON OFF
OFF ON
ON OFF
OFF
ON
5125-017
Battery
Inserted
Charging
Into
Status
Charger
Charger
connected
N O
to power supply.
Battery
YES
being charged.
Battery fully
YES
charged
.
Battery is charged but
not operational on tool.
This may indicate
YES
defective / bad
contact on battery or
charging conditions
are either too hot or
too cold.
Fig. 9
18