Page 1
113.211 R a t t l e S n a k e Tools required: Please note The OPITEC handicraft packs are not toys in a typical Wood Glue, off-the-shelf sense, but rather additional teaching and Paints and Brush (acrylic paint), learning material for educational purposes.
Page 2
Construction Manual 1. Sand (5) each of the 12 plywood segments (1) on two opposing sides as depicted. Then use the other sandpaper (4) to smooth the edges. 2. Paint the segments’ surface according to your taste. 3. EiEach single snake segment consists of two wooden segments. The wooden segments are connected by satin ribbons.
Page 3
Construction Manual red ribbon green ribbon red ribbon red ribbon green ribbon Segment 1 + 2 rotate 180° with the result that the finished upside of step B points downwards. Place the ribbons on the segment. Place a part of the 3rd segment with the smooth side pointing upwards onto the red ribbons at a distance of 3,5 to 4 cm to the 2nd segment.
Page 4
How it works: Hold the rattle snake at the thin side of the head next to its eyes and let its tail hang downwards. If the wrist performs a 180 degree rotation, the 2nd segment of the snake turns down. This causes a chain reaction which activates each segment successively.