Heatilator RAVE32-IFT-B Installation Manual page 27

Top Vent - Horizontal Termination
One Elbow
V Minimum
RAVE42-IFT-B
90° Elbow
1 ft. 305 mm 1 ft.
2 ft. 610 mm 5 ft.
3 ft. 914 mm 8 ft.
4 ft. 1.2 m 10 ft.
5 ft. 1.5 14 ft.
CAUTION: The SLP-HRC-SS termination caps are
not approved for use with these models. May lead to
elevated glass temperature that may cause tempered
glass breakage.
Note: Use SLP Series
components only.
Figure 4.12
Heatilator • RAVE32-IFT-B, RAVE36-IFT-B, RAVE42-IFT-B Installation Manual • 2619-983 Rev. U • 9/22
H Maximum
1
RAVE36-IFT-B
Not Allowed Not Allowed
305 mm 1 ft.
1.5 m 5 ft.
2.4 m 8 ft.
3.0 m 10 ft.
4.3 m 14 ft.
H MAX. =14 ft. (4.3 m)
V + H MAX. = 40 ft. (12.2 m)
RAVE32-IFT-B
1 ft. 305 mm
305 mm 2 ft. 610 mm
1.5 m 5 ft.
2.4 m 8 ft.
3.0 m 15 ft.
4.3 m
H MAX. =15 ft. (4.6 m)
V + H MAX. = 40 ft. (12.2 m)
Note: There MUST be a 25% reduction
in total H when using SLP-FLEX Series
(6-5/8 inch) vent except when using
the simple up and out installation. See
Figure 4.10.
H
1
1.5 m
2.4 m
4.6 m
V
1
27